Industrial Measurement Solutions
About Us Partners Latest News Contact us 
  Home :: Vehicle Dynamics :: Products :: OXTS GPS Inertial Units :: Inertial +


Inertial + Inertial +

Connect your existing GPS unit to the Inertial + for a complete GPS inertial solution which holds GPS position during drop outs from trees and other obstructions. The Inertial + also provides data on the vehicle orientation such as roll, pitch and yaw. 

The Inertial+ Navigation System is an extremely price competitive solution for improving measurements from a GPS receiver. Designed as a drop-in component the Inertial+ takes the serial NMEA data from your current GPS receiver, blends it with inertial sensors and outputs the improved data in the same NMEA format. Other input and output formats are supported. 

The Inertial+ provides smooth outputs without any GPS jumps or dropouts even near trees or tall buildings which makes it an  ideal cost effective system for all airborne or vehicle-based survey and mobile mapping applications.



Smooth Position

GPS often jumps because of multipath and changes to the satellite constellation. The Inertial+ measurements are computed from the gyros and accelerometers, which do not jump. GPS is used to update these measurements and prevent them from drifting.

Continuous Position

Even when GPS is not able to make a measurement, the Inertial+ will output from its inertial solution. Using a wheel speed odometer input the drift rate in position can be as low as 5 meters in 2 minutes.


As well as improving position and velocity measurements, the Inertial+ measures Heading, Pitch and Roll. These are important for correcting cameras or laser sensors.

Save Time

It takes a lot of time to correct poor GPS measurements by hand. Often geo-referenced data is lost because of poor GPS. Hours of time and many geo-referenced images can be saved with an Inertial+.


The Inertial+ system includes three angular rate sensors (gyros), three servo-grade accelerometers and all the required processing in one very compact box. An internal low-cost GPS provides accurate time alignment and makes it simpler to use.

Simple configuration software allows the user to change the mounting angle; displace the measurement point to a virtual location; change the GPS receiver type and many more. Once configured the Inertial+ works autonomously and does not require user attention. It can be used by non-skilled operators.

The internal logging enables the Inertial+ range of products to work stand-alone. Post-mission, data can be output in ASCII text format and loaded in to the software of your choice.

The outputs from the Inertial+ have less delay, or lower latency, than GPS. It is not necessary to wait for the GPS measurement before the data is output. The GPS corrections will still be accepted if they are more than 0.5s late.

The precision ADC in the Inertial+ systems gives more than 20 bits of resolution. The resolution of the acceleration measurements is 0.12mm/s² (12ug). The ADC oversamples the analogue sensors and uses coning/sculling motion compensation algorithms to avoid aliasing of the signals.

The internal processing includes the strapdown algorithms (using a WGS-84 earth model), Kalman filtering and in-flight alignment algorithms. The internal Pentium-class processor runs QNX real-time operating system to ensure that the outputs are always delivered on time.

Technical Specifications

Specification - Typical for RTK GPS
Parameter Inertial+
GPS Receiver Dependent
Positioning Accuracy
Velocity Accuracy

0.05km/h RMS

– Bias
– Linearity
– Scale Factor
– Range

10 mm/s²
100 m/s²
(Optional 30G)





Angular Rate
– Bias 
– Scale Factor
– Range

0.01°/s 1s
0.1% 1s

Update Rate


Calculation Latency



9–18Vdc, 15W

Dimensions (mm)

234 x 120 x 76


2.2 kg

Operating Temperature

–10 to 50°C

Shock Survival

100G, 11ms

Internal Storage

2 GB


See: Inertial+2